Add On: H-Hangar for HG/MG Gunpla

This time i want to review H-Hangar from the Wave  Corporation, its made in Korea. This add on consist of 8 plastic runner sets with two additional large pieces rectangle with the size of 80 x 160 mm that can be used as floor or wall. One assembling manual guide and also 1 set of sticker decals included.

After i try to assemble this H-Hangar, in my opinion the snapfit very tight. You can change the shape into 5 different types which can be seen on the back of the boxart. However, it can only fit 2 HG (without backpack) or one MG gunpla and i'm not suggesting to change the types too often, because the plastic can be stressed/broken. I tested it with my HG Oowashi Akatsuki Gundam and MG Gundam Age-2 Normal.

H-Hangar boxart (Front Cover)

H-Hangar boxart (Back Cover)

Manual Guide (Front Cover)
Manual Guide (Back Cover)

HG gunpla inside H-Hangar-a
HG gunpla inside H-Hangar-b

HG gunpla inside H-Hangar-c
HG gunpla inside H-Hangar-d

HG gunpla inside H-Hangar-e
MG gunpla inside H-Hangar-a

MG gunpla inside H-Hangar-b
MG gunpla inside H-Hangar-c


MG gunpla inside H-Hangar-d
MG gunpla inside H-Hangar-e


Pros:
  • This add on can be change into different types
  • It can be used for HG or MG gunpla
  • It can be combine with another set of H-Hangar
Cons:
  • The snapfit very tight
  • only fit 1 MG gunpla per set or 2-3 HG gunpla/set (without backpack)

2 Comments

  1. Not bad, probably need two sets for MG. I'm using Kotobukiya Mechanical Chain Base already.

    ReplyDelete
  2. @Dennis aka Katsuden: Yes, it will need 2 sets for MG gunpla. One is not enough hehe... I'm planning to buy Kotobukiya's Chain Base, i hope it can be combined with this one

    ReplyDelete
Previous Post Next Post